mbed Text LCD development board

This is my take on an mbed development board to support different LCD sizes.

The three sizes shown here are 20x4, 16x2, and 8x2.  Some LCD screens have a single row of 16 pins.  Others have two columns of seven (or eight) pins.  I developed this board to not hard-wire any connections except those dedicated on the mbed itself.  The LCD screen can be wired up in 4-bit (shown) or 8-bit mode using any available I/O lines.  Additional sockets are provided for USB host, USB device, Ethernet MagJack, and microSD.  Four switches with sockets are also provided.

eBible with power from Motorola

As most everything was socketed and not hard-wired, there's a lot of solder bridges connecting the sockets.  14 or 16 of the LCD socket connections are wired together in a mass of wire under the board.  This allows using jumper wires for just the top 16 wire socket, and plugging in any of the three LCDs that I have.  One of the LCDs was modified to grab power from the 2x7 socket.  Another has an additional two leads that are socketed.  The reason for the two different 2x7 sockets was that the functions of pins 1/2 were reversed on the 16x2 LCD display.  Alternatively, I could have used a switch or relied on changing the jumper wires.

The microSD has 7 connections, so just provided a 7x2 socket, and this requires jumpering the lines to the mbed.  I can then choose which SPI connections to make, and what line to be the chip select and/or card detect.  I attach a microSD breakout board from SparkFun.

The Ethernet MagJack is hard wired except for the LEDs.  A specific breakout board from SparkFun is required.

A USB device jack is socketed to support a mini USB device breakout board.  Alternatively a USB-A cable can be connected.

Power (3.3V) and ground buses are included, hard wired to the mbed.

PIC24 USB + Serial Development Board

Two main emphasis of this board are USB and Serial as well as using socketed components.  The 28-pin PIC24FJ64GB002 can perform as either a USB host or USB device, using jumpers to select between the connected USB socket.  The USB jumpers are also configured so when the PIC is USB host using the USB-A connector to attach a thumb drive, the USB-B connector may be configured to attach to an FTDI FT232RL chip to act as USB serial.  Using a USB-A to USB-B adapter, both the PIC and the FTDI chips could be active as USB devices. 

Two serial channels are jumpered for either RS-485 or RS-232 (DB-9 connectors not shown), or the second serial channel can be jumpered to the FTDI USB serial connection.  As configured here, RS-485 uses RX/TX with RTS to select whether reading or writing.  RS-232 can use RX/TX with CTS/RTS.  The ICSP (in circuit serial programming) connection in the lower left works with ICD or PICKit programmers, and shares the lines that provide CTS/RTS, so jumpers are provided to choose between those functions.  The PIC24 has quite a few 5V tolerant inputs, but I ran out of enough of them, so a 5V/3V3 logic level conversion board is socketed to read the CTS lines at 3.3V from the 5V MAX232 and MAX233. 

Voltage regulators are included to power 3.3V and 5V buses, accepting power from USB or 7V-12V external power.  Each module has a power jumper to effectively disable them.  The USB sockets have jumpers to selectively attach power to the 5V bus.

One SPI channel is also configured, allowing connection of features such as a micro SD card and/or SPI Ethernet.  This board specifically supports connection of a Microchip's PICtail Ethernet (ENC28J60) board.